Skip to content

Free roof inspections across Meridian Hills and nearby towns: (317) 707-6771

(317) 707-6771

ServicesTPO Roofing

TPO Roofing in Meridian Hills

Shingles need slope to shed water. On a porch, rear addition or flat section of your home, a white TPO membrane with heat-welded seams gives you one continuous waterproof sheet. We explain where it fits, how it's installed and what it costs to do right.

Roofer kneeling on a white TPO flat roof, heat-welding a membrane seam beside a parapet wall, with a roof drain and power cords nearby

What TPO Is and When It's the Right Material

TPO (thermoplastic polyolefin) is a single-ply roofing membrane, usually white, sold in rolls and joined with a hot-air welder. The welder melts the edges of two sheets together, so the seam becomes the same plastic as the field of the roof instead of a strip of adhesive or tape. That matters most on roofs where water sits for a while before it drains.

On houses, we use TPO on sections pitched below about 2:12: sunroom and porch roofs, garage roofs, rear additions and the flat middle of some older homes. Asphalt shingles installed that low tend to leak at the laps because water backs up under them. TPO also replaces worn built-up tar-and-gravel and rolled roofing, which crack and blister after years of freeze-thaw cycles in central Indiana.

It isn't the answer for every roof. If your main roof is steep, shingle roofing or metal roofing is usually the better fit, and we'll say so. Many homes end up with both: shingles on the pitched planes and TPO on the low section, tied together with proper flashing.

What a TPO Installation Includes

Tear-off and deck check
We remove the old covering down to the wood deck and look at every sheet. Soft or delaminated plywood gets replaced before anything goes on top.
Insulation board and tapered slope
Polyiso insulation board goes down first. Where water has been ponding, we use tapered board to build in a quarter inch per foot of fall toward the edge, scupper or drain.
Membrane, 60 mil standard
We generally install 60 mil membrane on homes because the extra thickness holds up better to foot traffic, hail and the occasional fallen branch. Sheets are fastened or fully adhered depending on the deck and wind exposure.
Hot-air welded seams
Every seam is welded and then probed along its length to find gaps before we leave.
Edge metal and wall terminations
Drip edge, termination bar and counterflashing where the membrane turns up a wall or meets shingles. Most low-slope leaks start at these transitions, not in the open field.
Cleanup
Old roofing, fasteners and scrap go off-site, and we run a magnet over the yard and driveway.

Signs Your Flat or Low-Slope Roof Needs Attention

  • Water standing two days after rain

    Ponding means the deck has sagged or the roof was built with no fall. Standing water speeds up wear and finds any weak seam.

  • Cracks, blisters or alligatored surface

    Built-up and rolled roofs dry out and split as they age. Blisters form where moisture is trapped between layers.

  • Ceiling stains under a porch or addition

    A brown ring under the low section usually traces to a failed wall flashing or a seam that has opened.

  • Shingles on a nearly flat pitch

    If someone shingled a low porch roof, leaks at the laps are common. A membrane is the lasting fix.

  • Soft spots underfoot

    A spongy deck means water has already reached the wood, and repairs only buy time.

What Moves the Price of a TPO Roof

TPO pricing depends less on square footage alone than on what sits under it and how it meets the rest of your home. We itemize each of these on the estimate so you can see where the cost comes from. Financing is available if you'd rather spread the payments out.

Deck condition

Rotted plywood found during tear-off adds material and labor. We photograph it before replacing anything.

Tapered insulation

Correcting a ponding roof takes more board and more cutting than a roof that already drains.

Wall and roof transitions

Every turn-up against siding, every skylight and every tie-in to shingles is detail work that takes time to weld and flash.

Layers to remove

Two or three old layers of built-up roofing mean more tear-off labor and disposal.

Access

A second-story flat roof over a patio costs more to stage than a garage roof reachable from the driveway.

How a TPO Job Runs

  1. 1

    Free inspection and measurements

    We measure the section and check its pitch, the deck, the drainage path and each wall and edge transition. Every problem spot gets photographed, and we go through those pictures with you. The estimate comes in writing, broken out line by line.

  2. 2

    Material and drainage plan

    We walk you through membrane thickness, attachment method and whether tapered insulation is needed. We pull the permit where your town requires one.

  3. 3

    Install day

    Most residential low-slope sections are torn off and covered in a single day, so the deck isn't left open overnight. Tarps protect landscaping and siding below.

  4. 4

    Seam probe and walkthrough

    We test the welds, check the edge metal and walk the finished roof with you before cleanup is signed off.

Roofer kneeling on a white TPO flat roof, pressing a seam by hand near a roof drain and vent pipe, with a parapet and suburban houses behind.

TPO Roofing Questions

How long does a TPO roof last on a house?

Lifespan depends on membrane thickness, how well the seams were welded and whether water drains off. A 60 mil sheet on a roof with proper slope holds up far longer than thin membrane on a deck that ponds. We'll tell you what to expect for your specific roof after the inspection.

Can TPO go over my existing flat roof?

Sometimes it can, if there's only one layer and the deck underneath is dry and solid. In most cases we recommend a tear-off, because trapped moisture in the old layers rots the deck and you can't see it from above. We check before recommending either.

Will a white roof look odd next to my shingles?

Low-slope sections are rarely visible from the street, so most people never see the membrane. Gray and tan TPO are also made if the section is visible from a window or deck.

Is TPO better than EPDM rubber?

Both work. TPO's seams are heat-welded rather than glued or taped, which we prefer for roofs that hold water briefly, and the white surface keeps the room below cooler in summer. EPDM is black and absorbs heat.

Can storm damage to a TPO roof be covered by insurance?

Hail punctures and wind-lifted edges are often part of a claim. We work with homeowners and insurance companies on storm damage claims, documenting the damage with photos; your adjuster makes the coverage decision. Our storm damage repair page covers that process.

White TPO membrane on a flat roof with a black drain dome, metal vent, roll of membrane, bucket and tool bag, with bare trees under an overcast sky

Find Out What Your Low-Slope Roof Needs

We'll check the pitch, seams and deck, show you photos and explain whether TPO, a repair or another material makes the most sense. We serve Meridian Hills and nearby towns including Carmel and Zionsville.